How To Prune A Braided Hibiscus Tree
Prune a braided hibiscus tree to encourage healthy growth and maintain its shape. Pruning allows you to remove dead or damaged branches and control the size of the tree. It also helps promote vigorous new growth, which will help your tree reach its full potential. With just a few simple steps, you can prune your braided hibiscus tree like a pro!
Steps for Pruning
The first step in pruning is to identify any dead or damaged branches that need to be removed. These should be cut off close to the trunk at an angle so that water does not collect on them and cause rot. Once you’ve identified all of the sections that need removing, it’s time for some shaping! You’ll want to start by trimming off small twigs from each branch – these are often overcrowded and give a messy look to your overall tree shape. It may seem counter-intuitive, but cutting away these smaller pieces will actually make the larger sections look fuller in comparison!
Next, use sharp pruners or shears (or even scissors!) To trim back larger branches along their length – this will help create more space between sections as well as open up light sources for other parts of your braid hibiscus tree. Remove any overly long stems as they can become heavy with flowers or foliage later on in life; keeping an eye out for crossed over areas where two main stems rub against each other is important too! Finally, carefully snip away any straggly ends left behind after your initial round of trimming – this will ensure a neat finish throughout all sides of the braid shape patterning around the trunk itself.
Additional Tips
When it comes to pruning a braided hibiscus tree, there are several additional tips worth bearing in mind: Firstly, avoid using fertilizer immediately following major prunings; nutrient levels can drop significantly during this process so giving them time before adding anything else is best practice! Secondly – Try not cut into old woody growth when possible; although some cuts may be necessary occasionally (for instance if diseased), doing so regularly won’t benefit long term health much & could end up harming instead! Finally – always remember general good hygiene before tackling projects such as these; sterilize tools prior & afterwards with rubbing alcohol and/or boiling water per manufacturer’s instructions whenever possible too – both steps help prevent unwanted spread of pests/diseases amongst plant populations widely accepted today thanks science!
